The internal memory is only holding 6 shots. The card is also holding only the same six. Help..

That leads me to believe you don't have the flash card properly seated inside and the camera is still only reading the internal memory. Make sure the contacts are cleaned and that you are properly installing it. You will know it is seated properly when it "clicks" as you place it inside. You push all the way in and then it clicks in place. To remove it,you push in again until it clicks and pops out.

I'd also try another card to see if you can replicate the issue. If you can, then it points to the camera as the culprit. If not, then it may be you just have a bad card.

Lastly, see if Kodak has a firmware update online that you can download and install. And reset the camera. This is a fairly easy procedure which involves either going into your setup menu and choosing "reset" (or intialize), holding down the menu key for 5 seconds, or, removing the batteries for a few minutes. It may be that the firmware loading got corrupted and the camera just needs to be "rebooted," which is something that turning it on/off won't accomplish. But after which, you should have the camera reset to factory default settings.